Impala lily (Adenium multiflorum) is a species in the same genus as desert rose, from southern Africa. Its care is similar in many ways, but three things set it apart: it flowers on leafless stems during its dry season, it has a strict winter rest, and it rots more easily than desert rose. Growing it as a bonsai adds pruning and wiring to the routine. For the general indoor routine that applies to most adeniums, see our desert rose care guide.
What makes impala lily different from desert rose
The names get mixed up, so check what you are buying. Some sources treat impala lily as a subspecies of A. obesum, and sellers sometimes swap the two names. The species is native to southern Africa, including parts of South Africa, Zimbabwe and Mozambique.
In the wild it usually grows 0.5–1.5 meters tall, occasionally up to about 3 meters, from a thick, swollen base that is often partly buried. It grows more slowly than desert rose. Seedlings often take three to five years, or longer, to flower.
Light, temperature and placement
Give it at least six hours of direct sun a day during its growing season. Indoors, a strong grow light can make up for a dim window. As with other adeniums, step a plant up to full sun gradually over a week or two rather than all at once.
Growth is best at about 20–35°C (68–95°F). Keep it above about 10°C (50°F). Its tolerance of cold when dry isn’t well established, so keep it frost-free.
Soil, pots and drainage
Use a very gritty mix: at least 60–70% inorganic material, such as pumice or perlite, with cactus mix for the rest. The mix has to drain almost at once. Pots need drainage holes.
Shallow pots suit impala lily, especially when it’s grown as bonsai. They keep the base in view and limit how much wet mix surrounds the roots.
Watering and feeding during active growth
Water during late spring and summer once the mix is dry, and let it dry again before the next watering. When leaves first appear after dormancy, start watering slowly, then increase as growth picks up.
Feed at half strength every three to four weeks, and only while the plant is actively growing. Stop feeding in autumn.
Winter dormancy and flowering
Impala lily drops its leaves in winter and rests. During dormancy, keep it almost completely dry. Its white flowers, edged with crimson-pink, often appear on bare stems during the dry season, which runs roughly May to September in its native range.
A leafless plant isn’t dead. It is resting, and it may flower. Watering a dormant plant to “wake it up” is a common way to cause caudex rot. Wait for new leaves before you increase watering.
Growing impala lily as bonsai
The basic rules are the same as for other adeniums. Bonsai adds more attention to pot size, roots and shape.
Choosing a pot and starting material
Impala lily is often grafted onto A. obesum rootstock. Check the graft and the health of the plant before buying. Use a shallow pot with good drainage.
Pruning and shaping
Prune in early growth or after flowering. Cut just above a node to build branches. Trimming works better once the plant has dried slightly, because heavy sap flow from fresh cuts can lead to branch rot. Let the plant dry a little before or after trimming.
Shape the plant by pruning where you can. Stems are brittle, so pruning is often safer than wiring.
Wiring
Wire lightly and briefly. Aluminum wire is commonly used, and a heavier gauge helps on thicker branches. Wire when the plant is drier and the branches bend more readily, and bend slowly. Check the wire regularly, and remove it before it bites into the bark.
Repotting and root work
Repot every two to three years, during active warm growth, and lift the caudex gradually rather than all at once. Remove the plant from its pot, trim roots with clean, sharp tools, and let the cut roots dry for several days before potting. Many growers wait about a week before the first watering so the cut roots can heal.
Repotting timing varies by climate. One experienced grower repots in the hottest part of the year, but in many climates spring is the usual time.
Common mistakes when pruning bonsai
- Removing too much at once. Don’t take more than about a third of the foliage in a single session.
- Cutting between nodes or leaving stubs. Cut just above a node.
- Pruning when sap is running freely. Let the plant dry a little first, so fresh wounds aren’t left wet.
- Watering during dormancy. A plant that is resting needs very little water.
- Repotting into wet soil, or planting roots before the cut ends have dried.
- Wiring thick or brittle stems tightly, which can crack them or leave marks.
Common misconceptions
- Impala lily is not a true lily. True lilies belong to the genus Lilium. Impala lily is an Adenium, a succulent in the oleander family (Apocynaceae).
- A leafless plant is not dead. It is resting.
- It doesn’t follow desert rose’s flowering schedule. Impala lily tends to flower in the dry season, on bare stems.
Buying and conservation
Buy nursery-propagated plants. Impala lily is listed as vulnerable on South Africa’s Red List, so wild-collected plants are a conservation concern. If you plan to start from a cutting instead, see our impala lily cutting guide.
Safety
All parts of impala lily are toxic, and the sap contains cardiac glycosides. Wear gloves when pruning or wiring, and wash your hands and tools afterward. Keep it away from children and pets. For pet-specific guidance, see our guide to whether desert rose is poisonous to cats and dogs.