Succulent and Cactus Care

Cactus and Succulent Soil: Rice Hulls, Worm Castings and Gritty Mixes

Build a cactus and succulent soil mix with rice hulls, worm castings and grit, including ratios, grit size, dust safety and common mistakes.

On this page
  1. What a cactus or succulent mix has to do
  2. A simple mix: potting soil plus pumice or perlite
  3. What is the best way to make my own cactus soil mix?
  4. Can you add perlite to cactus soil?
  5. Is rice husk good for plants?
  6. What helps cactus grow faster?
  7. Worm castings: a small share only
  8. Mixing, storing and dust safety
  9. Common mistakes

Rice hulls, worm castings and grit all have a place in a cactus or succulent mix, but the ratios matter more than the ingredients. A good mix drains within seconds of watering and dries within a few days to a week. This guide shows how to build one and how much of each ingredient to use.

What a cactus or succulent mix has to do

A cactus mix has two jobs. It has to keep enough air around the roots, and it has to drain quickly enough that the roots are not left sitting in water. Most of the mix should be mineral material, not peat, bark or compost. For cacti, aim for about 60–70% mineral. For most other succulents, about half mineral is a sensible starting point.

A simple mix: potting soil plus pumice or perlite

If you have no specialist ingredients, mix one part potting soil or coir with one part pumice or perlite, by volume. That gives roughly half mineral material, which suits many succulents. For cacti, add a little more grit.

Pumice is a volcanic rock with air pockets. It holds a little water, and it does not float to the surface. Perlite is lighter and tends to float up over time, so the top of the pot can end up full of it.

What is the best way to make my own cactus soil mix?

A well-known gritty recipe uses equal parts pine bark fines, calcined clay (such as Turface) and granite grit, by volume. That mix is about two-thirds mineral and drains very quickly. It suits cacti and succulents in pots with drainage holes. It also holds few nutrients, so feed the plant lightly during the growing season.

Choosing grit

Use coarse grit, about 3–6 mm, and sieve out the fine dust. Dust fills the gaps between particles and holds water. Use coarse horticultural sand only. Fine play sand or builder’s sand packs down and stays wet. Gravel in the bottom of a pot does not replace a gritty mix throughout.

Can you add perlite to cactus soil?

Yes. Perlite is a cheap, common addition that improves drainage and aeration. Because it floats up over time, mix it in thoroughly and top the pot with a layer of grit to keep it in place. Pumice does not float and holds slightly more water, so it works well as a longer-lasting alternative.

Is rice husk good for plants?

Rice husk, also called rice hull, is useful as a drainage material in a pot mix, but there are three different products to know about:

  • Raw rice hulls are a lightweight stand-in for perlite. They break down slowly over a year or two, so the mix will need refreshing.
  • Parboiled rice hulls (PBH) are steam-treated, which reduces weed seeds and some pathogens.
  • Carbonised rice hulls (CRH) are charred, porous and sterile. They improve drainage and aeration. They are usually alkaline, around pH 8 or higher, though this varies by batch.

Use rice hulls at about 10–30% of the mix by volume. Raw hulls and CRH are not interchangeable. Wear a dust mask when mixing dry CRH.

What helps cactus grow faster?

Good light, the right pot and a mix that dries properly do the most. Light feeding in the growing season helps too. Worm castings can add a little nutrition, but they are a mild source, not a fast fix. More castings do not mean faster growth.

Worm castings: a small share only

Worm castings (vermicast) are a mild source of nutrients. Use them at about 10–20% of the mix by volume. They are not a full replacement for fertiliser, because their NPK content is low and varies with what the worms were fed.

What are the disadvantages of worm castings?

In large amounts, worm castings hold too much water, which is the opposite of what a cactus mix needs. They also do not supply enough nutrition to replace feeding in the growing season. Keep them to a minority share of the mix, and balance them with plenty of grit.

Mixing, storing and dust safety

Mix the dry ingredients in a bucket or tub. Wear a dust mask when working with perlite, pumice or dry CRH, because the fine dust irritates the airways. Sieve the grit, and keep the mix dry until you use it.

Common mistakes

  • Sand alone: fine sand compacts and stays wet.
  • Too many worm castings: they hold water and invite rot.
  • Treating rice hulls and CRH as the same: raw hulls are organic filler, while CRH is charred and alkaline.
  • Gravel at the bottom: it does not replace a gritty mix.

For the difference between succulent soil and ordinary potting mix, see is succulent soil different than potting soil?. For the full set of care topics, start with how to care for succulents and cacti. For improving soil in the ground rather than a pot, see planting succulents in garden beds.

The complete guide to succulent and cactus care

How to Care for Succulents and Cacti: Light, Water, Soil and Pots
Read the guide

Keep exploring

Guides from other topics

All topics →