Succulent and Cactus Care

Is succulent soil different than potting soil?

Is succulent soil different than potting soil? Yes. Here is why standard potting mix stays too wet, what a succulent mix contains, and how to test one.

On this page
  1. Why potting soil holds too much water
  2. What is in a succulent mix
  3. Can you use potting soil for succulents?
  4. Reading a bag of cactus mix
  5. Making a succulent mix at home
  6. Common myths
  7. How to tell a mix works
  8. Safety

Yes. Succulent and cactus soil drains much faster and holds far less water than standard potting soil. Potting soil is designed to stay evenly moist. A succulent mix is mostly mineral grit, which lets water run through and lets the pot dry out within days.

Why potting soil holds too much water

Standard potting soil is mostly peat, coir, bark and compost. Those materials hold water so that plants stay evenly moist. Many potting mixes also contain wetting agents and fertiliser, which keep the mix damp and rich. Succulents need neither. Over time, a dense, moisture-holding mix can keep roots wet long after the top of the pot has dried.

Dry peat adds another problem. Once it dries out fully, it becomes hydrophobic, so water runs off the surface rather than soaking in. A pot of dry peat-based mix can look dry and still take in water poorly at first.

What is in a succulent mix

A succulent or cactus mix is built on mineral material: pumice, perlite, coarse grit, calcined clay or lava rock. A homemade target is about half mineral for most succulents and 60–70% for cacti. Good grit is coarse, around 3–6 mm, and fine dust should be sieved out, because dust clogs the pores and holds water.

Can you use potting soil for succulents?

You can, if you heavily amend it. Mixing one part potting soil with one part pumice or perlite, by volume, gives a much faster-draining base. Straight potting soil raises the risk of rot, because it stays wet for too long. For succulents planted in the ground, see soil prep for garden beds.

Adding sand alone does not fix potting soil. Fine sand clogs the pores and makes the mix denser. Use coarse grit or pumice instead.

Reading a bag of cactus mix

Many bagged cactus mixes are still peat-heavy, so the label can mislead. Check the ingredients, then feel the mix. If it is mostly dark, fine and crumbly, it will hold water. If you can see pieces of pumice, grit or perlite, it is more likely to drain well. Many growers add an extra 30–50% pumice or perlite to bagged mix to get the drainage they need.

Making a succulent mix at home

A simple home mix is one part potting soil or coir to one part pumice or perlite, by volume. That gives about half mineral material, which is enough for many succulents. For cacti, add more grit. For full ratios, see cactus and succulent soil.

Common myths

  • “Gravel at the bottom fixes potting soil.” It does not. It creates a wet layer above it and worsens waterlogging higher in the pot. See shallow or deep pots.
  • “Adding sand makes potting soil suitable.” Fine sand clogs pores. Use coarse grit or pumice.
  • “Succulent soil is the same as orchid mix.” Orchid bark mix is too coarse and too organic on its own.
  • “Cactus mix from the bag is always gritty enough.” Many are not. Check the label and the feel.

How to tell a mix works

A good mix lets water run straight through when you water, and the pot is dry within a few days to a week. If water sits on the surface, or the pot stays wet for a week or more, the mix is too dense. Add more grit, or repot in a mix that drains faster.

Safety

Wear a dust mask when mixing dry perlite, pumice or peat. Fine dust can irritate the airways.

For full ratios, see cactus and succulent soil. For how poor drainage leads to rot, see overwatered succulent signs and rescue.

The complete guide to succulent and cactus care

How to Care for Succulents and Cacti: Light, Water, Soil and Pots
Read the guide

Keep exploring

Guides from other topics

All topics →