A vertical succulent garden turns a wall, fence or railing into a planted panel. It’s a good way to use a small footprint, and succulents suit it well because their roots stay shallow and they need little water. The catch is that a panel holds far less soil than a pot, dries from the top down, and gets heavy when wet. Build it with those limits in mind, and it can stay attractive for a long time.
What you need: a DIY frame or a commercial panel
Two approaches work:
- DIY shadow box. Build or buy a box about 5 to 8 cm (2 to 3 in) deep, with a plywood back and hardware cloth across the front. The mesh is typically about 1 to 2.5 cm (½ to 1 in).
- Commercial panel. Modular plastic cell trays and felt pockets are common. Cells are often about 5 to 8 cm across, but sizes vary by brand, so measure one before you buy plants.
Either way, you’ll need:
- A fast-draining succulent mix. A little coir or sphagnum moss helps it cling to a vertical surface.
- A liner of sphagnum moss or landscape fabric between the mesh and the soil, so the soil stays put while roots grow through.
- Hardware cloth or chicken wire, a staple gun or small nails, and gloves. The cut edges of mesh are sharp.
- A chopstick or small trowel for tucking plants into the mesh, and a spray bottle.
Choose a spot and light
Succulent panels need about 4 to 6 or more hours of bright light a day. Outdoors, a spot with morning sun and afternoon shade suits softer-leaved plants. Indoors, a bright south- or west-facing wall works best, or you can add a grow light. A wall in constant shade will stretch the plants quickly.
Wall-mounted panels need a waterproof barrier behind them and an air gap between the panel and the wall, so moisture can’t rot the wall or the frame. On a large wall, timed drip irrigation with a collection trough below can handle the watering, which saves hand-watering a big panel.
Build and plant the panel
- Prepare the frame. Build a sturdy box, or prepare a commercial panel. If the wood will be outdoors, seal it.
- Line the box. If you use plastic, poke drainage holes through it so water can escape.
- Add soil. Fill the box with fast-draining succulent mix and tamp it lightly. You want it firm, not packed.
- Fix the mesh. Secure the hardware cloth or chicken wire over the front with a staple gun or small nails, pulled taut so the soil can’t spill out.
- Callus and plant. Let cuttings callus for two to seven days so the cut ends can seal. Then push each cutting or plant’s roots through the mesh into the soil, and pack the plants close together.
- Lay it flat to root. Keep the panel flat in a bright spot for four to eight weeks, until the plants have anchored. Give one plant a gentle tug. If it resists, it has rooted. Don’t yank.
- Hang it. Only hang the panel after it has rooted. Hanging too early can make cuttings and soil fall out.
Choose plants for a panel
Good options include Sedum, Sempervivum, Echeveria, Graptoveria, Crassula, small Aeonium and string of pearls (Curio rowleyanus). Mix colors, textures and sizes for interest.
Put the most drought-tolerant plants at the top. The top rows dry out first, and the bottom rows stay wet longest. Avoid heavy or tall plants, such as large Aeonium and Agave. They tend to pull loose from shallow soil.
Water the panel
Water the panel while it’s flat so the water soaks through evenly. Water thoroughly, let it drain completely, then hang it back up. In warm weather, a common rhythm is roughly every 7 to 14 days, but the right interval depends on your climate, the plants and the depth of the panel. Check the soil before each watering.
Misting helps newly planted cuttings during rooting, but it isn’t a substitute for thorough watering once the plants are established. A light mist only wets the surface.
Keep it healthy
Overwatering, not drought, is the usual failure. The lower rows rot first because water collects there. If leaves turn soft, mushy or translucent, pull that plant out, let the pocket dry, and check the rows below for rot before replanting.
Replace plants that stretch or drop out. Trim straggly stems in spring and late summer. Refresh the soil every two to three years, since the mix breaks down over time.
Weight and mounting safety
A wet, soil-filled panel is heavy. Depending on its depth, it can weigh roughly 50 to 100 kg per square meter (about 10 to 20 lb per square foot). Fix heavy panels into wall studs or masonry, not drywall anchors alone. Wear gloves when you cut hardware cloth.
For more on light and general care, see succulent gardens for small spaces. If you’d rather build something enclosed, see succulent terrariums.